CITP

CITP is a protocol used by lighting desks for the transfer of thumbnails and asset specific naming for previewing when programming.

  • GrandMA2 3.1.2.5 supported. Version after 3.2.2.3 should also work.

  • Hog OS 3.5.0

  • CITP devices join with both multicast addresses, 224.0.0.180 and 239.224.0.180, and in that order.

In Disguise software:

  1. Right-click on Devices.

  2. Create a new DMX Device.

  3. Insert the desk's IP Address (this should ideally be set up on an isolated Art-Net switch).

  4. Create a CITP Device and assign the DMX Device to it.

  5. Add a Video Layer, assign a DMX patch to it.

  6. Open the Bank Editor and populate the Video banks.

In GrandMA2:

  1. Go to Setup > CITP Network Configuration.

  2. In the top-right corner of the windows that oepsn, ensure you set CITP to Enabled (the box should look green once you click it).

  3. Right-click on "New" under the MediaServers tab.

  4. The Disguise machine should appear in the list here. Click to select it.

  5. Select a fixture layer (one with a Video layer fixture patched to it).

  6. Select a Library SubAttribute (any sub-attribute seems to work as Disguise doesn't use this.)

  7. Select an Image SubAttribute (this needs to be set to Video Slot)

  8. Click on Update Thumbnails

  9. Select the Video layerFixture and navigate to the Video Slot attribute

  10. Clicking on the attribute should now display clickable thumbnails and file names on the lighting desk software

Please note: If the machine does not appear in the MediaServers list, double-check connection settings (use the DMX Monitor to ensure DMX is being received) and ensure the CITP Device is in the Device List.