Setup Analog Way OPS300

  1. Navigate to the Network Settings page of the Analog Way OPS300 interface. Note down the Remote Address and Remote Port numbers used or set your own. Please see your devices manual for more instructions.

    Note down the Remote Address and Remote Port numbers used or set your own from the Analog Way OPS300 Network Settings page

  2. Set the matrix to be in the same IP range as the Disguise system.

  3. In Disguise software, create an AnalogWayOPS300 device. An AnalogWayOPS300 device is created in the same way as any other device type. Please see the previous sub-chapter Creating devices for step-by-step instructions on how to create a device, and select AnalogWayOPS300 from the menu of different device types. This will open the AnalogWayOPS300 device editor.

  4. Configure the device using the properties contained in the AnalogWayOPS300 device editor (explained below).

AnalogWayOPS300 device editor

IP address

The IP address of the matrix.

Port

The TCP port number configured in the matrix.

Test preset

The test preset number

Test

This button will set the matrix to the preset set in the test preset # property.