Setup Barco MatrixPro

The Barco MatrixPro can either be controlled via Serial or TCP-IP. If creating a Serial device it will take priority over the IP configuration.

  • In Disguise, create a BarcoMatrixPro device. A BarcoMatrixPro device is created in the same way as any other device type. Please see the earlier sub-chapter Creating devices for step-by-step instructions on how to create a device, and select BarcoMatrixPro from the menu of different device types. This will open the BarcoMatrixPro device editor.

  • In the Port property create a new SerialDevice. Use the same process as that for creating the BarcoMatrixPro device, but select SerialDevice from the menu of different device types. If creating a SerialDevice it will take priority over the IP configuration.

  1. Configure the Barco MatrixPro to the same IP network as the Director/Actor network.

  2. Configure the device using the properties contained in the BarcoMatrixPro device editor (explained below).

BarcoMatrixPro device editor

Port

The UDP port to send commands on.

IP address

The IP address of the matrix.

Test preset

The test preset number.

Test

This will set the matrix to the preset set in the test preset property.