Setup Lightware Matrix

  1. Configure the Lightware matrix to the same IP network as the Director/Actor network.

  2. Choose port 10001 in the matrix configuration.

  3. In Disguise, create a LightwareMatrix device. A LightwareMatrix device is created in the same way as any other device type. Please see the previous sub-chapter Creating devices for step-by-step instructions on how to create a device, and select LightwareMatrix from the menu of different device types. This will open the LightwareMatrix device editor.

  4. Configure the device using the properties contained in the LightwareMatrix device editor (explained below).



    5. Please note: Currently only the LW2 protocol can be used to configure the Lightware matrix and the disguise software. Newly released devices from Lightware use LW3 protocol; therefore LW2 must be enabled in the Lightware Device software in order to be used with disguise.

IP address

The IP address of the matrix.

Port

The TCP port number configured in the matrix. Set it to 10001.

Test preset

The test preset number.

Test

This button will set the matrix to the preset set in the test preset property.