MatrixControl

The MatrixControl layer allows you to animate matrix presets on the Timeline. Currently, Disguise software has built in matrix devices for a number of matrices.

Matrix

The matrix device you want to control.

Command

The preset you want to trigger.

The process used to create/sequence DVI matrix presets is done by placing keyframes onto the Command keyframe editor, and is therefore the same as any other layer type that uses keyframe editors, for example the AnimateCameraPreset layer. 

There are three types of matrix presets:

Editing MatrixControl commands

Each MatrixControl command type opens a specific command editor.

MatrixCommandAutoTrans 

Transition with a specified transition time . Only applicable for the Barco Encore.

MatrixCommandCut

Transitions with a hard cut. Only applicable for the Barco Encore.

MatrixCommandPreset

Changes the preset of the matrix. This will only work if you already configured a DVI matrix.

  1. First, create a new matrix device in the Device manager, for example Lightware matrix or BarcoMatrixPro. Make sure the ip-address of the matrix device is in the same network as your Director/Actor network.

  2. Create a new MatrixControl layer.

  3. Choose the matrix device you just created.

  4. Create a new command. For a matrix preset, choose the MatrixCommandPreset

  5. Type in the number of the preset.

  6. To animate presets, drag and drop them onto the keyframe editor.